Body
St. John Fisher University provides wireless access in all buildings on campus including Residence Halls, Academic, and Administration Buildings. The university offers secure Wi-Fi networks to provide enhanced wireless connectivity to the Fisher Community. When purchasing a device that will connect to Wi-Fi on campus, make sure that it supports at least 802.11ax standard.
All faculty, staff, and students can connect to "SJF-WiFi" or "SJF-Legacy" (secure & encrypted) using their SJF network credentials.
In Academic & Administration Buildings, and Residence Halls
SJF-WiFi supports WiFi 7 standard and utilizes the WPA3 Enterprise protocol. WPA3 Enterprise is built into most current operating systems and mobile devices. Users connect to this primary network through a secured encrypted connection. The secure network is available for all St. John Fisher owned/managed devices as well as any personal devices (BYOD).
SJF-Legacy will utilize the WPA2 Enterprise protocol. WPA2 Enterprise is built into all current operating systems and mobile devices. Users connect to this secondary network through a secured encrypted connection. The secure network is available for all St. John Fisher owned/managed devices as well as any personal devices (BYOD).
SJF-Guest is an open wireless network routed directly to the Internet. The unencrypted public Wi-Fi connection provides basic access with no security and slower speed than SJF-WiFi.
All connections to the SJF network, including guest Wi-Fi, are subject to the University’s Acceptable Use Policy (AUP).
Settings to connect to SJF-WiFi
Apple (iOS) Devices:
- Username = username
- Password = [your SJF password]
- Certificate = select "Trust" (top right)
Once connected, a check mark will be displayed by SJF-WiFi
Android Devices:
Android 12 or newer:
- EAP Method = PEAP
- Phase 2 Authentication = MSCHAPV2
- CA Certificate = Use system certificate
- Online Certificate Status = Do not verify
- Domain = sjfc.edu
- Identity = username
- Passsword = [your SJF password]
- Anonymous identity = leave blank
With correct settings, "Obtaining IP Address" will be displayed and then Connected.